Armada / Titan Stainless Steel 4 Piece Grille Set

From E & G Classics, Stainless Steel Grille for your Nissan Titan and Armada.
Mounts over factory grille, no need to remove the factory grille.

KIT CONTENTS
• Left "Q" Grille
• Center "Q" Grille
• Right "Q" Grille
• Lower "Q" Grille
• Mounting Brackets - 8
• 8-32 Half ESNA Nuts - 8
• Black Silicone Sleeves .187" x 1.5" - 8
• Hardware Kit
• 5' Black Edge Guard Moulding

INSTALLATION INSTRUCTIONS - Top Grille
1) For lower grille installation, you must first remove the philips screws that hold the front tag bracket in place (if equipped).
2) Remove protective cover from front of lower grille. Install the supplied black silicone sleeves to the mounting studs on back of grille (trim the ends off with cutters or a razor blade). Install the black trim guard around the edge of the grille.
3) Align the lower grille into the opening, making sure it is oriented correctly (the radii are different top to bottom, check to see which way fits best). Install the lower mounting brackets and ENSA lock nuts until the grille is snug. Do not overtighten or you could dent the grille.
4) For vehicles equipped with a front tag bracket, grind the upper portion of the screw boss flat, leaving the screw hole intact. This will allow the tag bracket to fit flush against the grille, reusing the factory mounting holes.
5) Reinstall the modified front tag bracket using the #10 x 1-1/2" Pan head screws supplied in the hardware kit. The screws will pass between the frame and the lower fin and reuse the existing tag mounting holes.

INSTALLATION INSTRUCTIONS - Lower Grille
1) Open the hood and remove the radiator support panel cover. Apply protective tape to all three grille surround areas to protect the factory grille.
2) Cut the ends off the black silicone sleeves and install them onto each mounting stud. Align the upper grille sections into place. Install the mounting brackets over the protruding studs and install the supplied ESNA half nuts to secure.
IMPORTANT: Do not over tighten the ESNA nuts or you could dent the stainless steel grille at the stud locations.
3) Once all the hardware is tight, remove the protective masking tape and replace the radiator support panel cover to finish.